This is the last of the projects we made in my Club Classes this month. It features the Every Blessing Set and the Flurry of Wishes Set. It also showcases the Bouncing Brayer technique.
Uses Every Blessing Clear-Mount Set and Flurry of Wishes Photopolymer Set plus Elegant Eggplant Classic Stampin' Pad, Perfect Plum Classic Stampin' Pad, Perfect Plum Card Stock, Sahara Sand Card Stock, Very Vanilla Card Stock, SNAIL Adhesive, Stampin' Dimensionals, Tear & Tape Adhesive, Sahara Sand 7/8" Lace Trim, Metallics Sequin Assortment, 1/8" Mini Brads, Heat Tool, Embossing Buddy, Silver Stampin' Emboss Powder, Brayer, VersaMark Pad, Paper Snips, Craft Scissors, Paper-Piercing Tool, Stampin' Pierce Mat, Stampin' Trimmer, Clear-Mount Block B, Clear-Mount Block D, and Clear-Mount Block E.
We simply bounced an inked up Brayer at an angle from the top left corner onto a piece of Very Vanilla Card Stock a few times. We rotated the Brayer wheel slightly every so often. Then, we lightly ran the Brayer over the whole piece and then added a few more rays by bouncing the Brayer again. Next, we rubbed the whole piece down with the Embossing Buddy before stamping the main image and heat embossing it.
The star is made from the center of the largest snowflake in the Flurry of Wishes Set that is stamped and cut out by hand. We then secured a silver sequin to the center with a 1/8" Mini Brad.
I did cut apart my main image from the Every Blessing Set so that I could easily stamp only the images I wanted.
You can place an online order for some of the products used on this card by simply clicking on the image of them below. This will take you directly to my online store! Or, contact me at [email protected] to have me place an order for you!
Comments